
What you are building
The Compact Automatic Sticky Piston Door Gate provides a seamless, secure entryway for underground bunkers, castle walls, and survival bases. Utilizing concealed sticky pistons and standard redstone components, this design keeps your base safe from wandering monsters while granting hands-free access whenever you walk through.
This build works wonderfully as a main entrance gate or an internal bulkhead between rooms. Because this schematic originates from an older format, the underlying redstone mechanics have remained reliable for years, but it is always recommended to test it in a creative world before committing resources in survival.
Materials 298 blocks · 9 types
- Stone Bricks1502 stacks + 22
- Iron Block741 stack + 10
- Redstone Wire34
- Stone Slab16
- Redstone Torch6
- Sticky Piston6
- Stone6
- Stone Pressure Plate4
- Glowstone2
How it works
The mechanism relies on an inverted redstone torch circuit powering columns of sticky pistons. Under default conditions, redstone torches keep the sticky pistons fully extended, holding the central iron blocks closed across the doorway.
Stepping onto the stone pressure plates routes a redstone wire signal beneath the floor directly into the blocks supporting the torches. This temporarily turns the torches off, cutting power to the sticky pistons and causing them to retract instantly. Once you walk clear of the pressure plates, the signal drops, the torches relight, and the pistons push the iron blocks back into the closed position.
How to use it
To operate the gate, simply walk across the stone pressure plates positioned in front of the door frame. The door retracts automatically to let you pass through and will seal behind you once you clear the corresponding pressure plates on the opposite side.
Lay Foundation and Lower Redstone
Layers 1–4 of 7Lay down the base layer using Iron Blocks and Stone Bricks to establish the 12x5 footprint. Carve out the central walkway and run Redstone Wire beneath the floor connecting to where your Stone Pressure Plates will sit.
Set up the Sticky Pistons facing inward along both sides of the corridor, alongside the Redstone Torches that will power them. Begin raising the outer stone brick shell up to layer 4 to hide the piston mechanisms.

Enclose the Pistons and Add Lighting
Layers 5–7 of 7Build the remaining stone brick walls up to layer 7, sealing off the piston bays completely and bridging across the top of the central passage with stone brick framing.
Cap the upper corners with two Glowstone blocks to illuminate the entrance, and ensure the upper redstone dust connections link the top pistons to the lower torch columns so both tiers fire simultaneously.

Finishing touches
Test the gate by walking over the pressure plates from both directions to verify that all sticky pistons retract and extend in sync. If one side sticks or fails to open, inspect the underfloor redstone wire to ensure the line does not lose signal power before reaching the torch bases.
Frequently Asked Questions
Can monsters trigger the door?
Yes, standard stone pressure plates can be triggered if a mob steps directly onto them. Make sure the exterior approach is well lit to prevent hostile mobs from walking up to your gate.
Why do the top pistons not retract?
Check that the redstone signal reaches the block directly above or behind the top pistons. Ensure no solid blocks are cutting off the redstone dust path running up the side towers.